Hi Benjamin (@BMTUD),
we have released a new SweepMe! version 1.5.8 as beta where we now support dynamic sweep values:
Now, the sweep editor can now renew its list of sweep values also during the measurement not just at the very beginning.
Because of that you do no longer need a Condition module to skip superfluos values, but rather directly use the Form input parameters in the Sweep editor. For each higher iteration in the sequencer, the Sweep editor is evaluated again. By this users can change at each repetition for example start and end voltage of an IV curve and the Sweep editor makes sure that a new sequence of apply values is created.
Feel free to test it and let us know your feedback at the above mentioned forum post or open a new topic.
Best, Axel